Galaxy S9+ photo tripod support
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I needed a way to put my brand new phone on my tripod securely, without risking to scratch it. Using this you can…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 151
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution
I needed a way to put my brand new phone on my tripod securely, without risking to scratch it.
Using this you can still access the charging port and the button(s) on one side of the phone. You get full screen touchability but you can't put your tripod upside down (obviously).
There is no thread in the screw mount, but forcing a 1/4" screw in the hole is fine and very secure as long as it's deep enough inside the hole.
Included is the OpenSCAD source file and the resulting STL file.
Can be adapted for a S9 if you change the phone measurements in the source file.
Print Settings
Printer:
Anet A8
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.3mm
Infill:
20%
Notes:
Should print flawlessly on any printer with a large enough bed.
I started by looking up the official measurement of the phone, then got my caliper for the rest (button size and position. There is a generous hole for an USB-C connector.
Category: Mobile Phone