Oculus Quest 2 Elite Strap Battery Box for Anker PowerCore10000
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This holds an Anker PowerCore10000 power bank onto the collection of Elite Strap clones here for the Oculus Quest 2. I…
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 534
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Virtual Reality
- Licencja
- Creative Commons — Attribution
This holds an Anker PowerCore10000 power bank onto the collection of Elite Strap clones here for the Oculus Quest 2. I found other solutions for holding the power bank too hard to use.
I didn't have any good rubber bands, and wasn't about to waste a zip-tie.
I slightly enlarged the retaining tabs over what I printed for myself (V6) - let me know if you cannot get the battery in.
Print this in TPU!
Remixed for use with:
www.thingiverse.com/thing:4636924
www.thingiverse.com/thing:4629958
www.thingiverse.com/thing:4635406
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
12
Filament: Any TPU Any/Black/White
Notes:
I printed with "detect bridging perimeters" off in Prusa Slicer, sometimes, TPU will not come off supports without a larger gap when that's on.
After printing, remove from bed.
Tip the support for the square 'dovetail' away from the case, it should come right off, and you can push the small support over the button hole out similarly.
At the top of the print, there are two semi-circles that should have one sparse layer I cut those out with a razor, though side clippers will also work. I've shown where to cut in red.
Trim Here with Razor to remove print aid.
Category: Gadgets