Nesting TPU RC Road Cones, Self-righting
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I wanted a set of road cones (I was using old tires but when you hit one they tend to roll away) for my RC car, with a…
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 238
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
I wanted a set of road cones (I was using old tires but when you hit one they tend to roll away) for my RC car, with a few criteria:
Don't roll away when you hit them.
Next to carry easily (these stack on remote's antenna)
Print quickly, don't use a lot of material
Can get run over without serious damage by a full sized car
I would like to add a feature (tabs) so they lock together but I haven't bothered yet.
These bridges are just a BIT far, with the printer miscalibrated they don't come out perfect.
That said I've been using them for months and been very happy with them. It's nice to have a couple in different colors for "inside" cones.
Print Settings
Supports:
No
Filament:
any Semi-Flex TPU
Notes:
These should just pull right off the printer.
Category: R/C Vehicles