All In One 3D Printer Test with real supports
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Overall, I liked the original, but the support test had pre-defined supports that were completely attached to the…
- Ocena
- 5 / 5
- Polubienia
- 39
- Pobrania
- 757
- Wydruki
- 3
- Wyświetlenia
- 3010
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Attribution
Overall, I liked the original, but the support test had pre-defined supports that were completely attached to the horizontal platform, negating the test and making the print use more material and take more time without actually testing the support features in the slicer.
This model has a simple 90-degree ledge in the same location, but you must now define supports in your slicer.
Print Settings
Printer Brand:
Creality
Printer:
CR-10
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
100%
Filament: Sunlu PLA Plus Orange
Notes:
You must now enable supports in your slicer for this remixed version!. Make sure support angle is set to >80 degrees (I used 82), or you'll get them under the overhang tests. Also, you'll have to place a support blocker over the bridging tests, otherwise they will also end up with supports.
If you don't see the supports after slicing, you probably have supports set to too steep of an overhang angle, or you have them set to attach to the build plate only.Category: 3D Printing Tests