1 / 12
sunlu filament dryer filament / ptfe plug V2 new design, MODDING NEEDED to dryer — zdjęcie 1
1 / 12

sunlu filament dryer filament / ptfe plug V2 new design, MODDING NEEDED to dryer

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

a new version of my ptfe plug, this will help with the feed angle (45 degrees) to avoid rubbing.

Ocena
0 / 5
Polubienia
8
Pobrania
46
Wydruki
1
Wyświetlenia
863
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

a new version of my ptfe plug, this will help with the feed angle (45 degree up/down/left/right) to avoid the rubbing that my original sometimes got depending on the filament. 

A benefit of this new design is it is suitable for feeding the filament whichever way round you prefer the roll to be and also because its printed as a print in place the centre rotates freely so when the reel is at the sides the adapter will adjust also.

you will need to adapt/mod the dryer (see pics) as the original hole is too small, so I have included a template (I used a biro but a marker will be better as I still had to trim a little bit more) to print for the correct size cut out needed, a hobby tool is recommended to cut the aperture, when marking the cut DON'T go too low because of the heated metal plate inside (see pic) I would position it 60% top/40% bottom.  REMEMBER to clean all loose bits (keeping it upside while cutting helps also use a microfibre cloth to wipe inside the dryer  after cutting so it doesn't cause a fire). I switched my dryers on for a bit after fitting without filament just to check no debris was melting inside.

print  at 75% speed with ptfe adapter end facing up (see pic), no supports are needed just free the adapter carefully after printing. there may be some loose strands from the edge bridging just remove them so they don't impede the fitting.

I made inner filament hole slightly larger on this version so it shouldn't need a 2mm drill bit to clean the hole this time, but try some filament after printing just to check alls good.

I haven't glued mine in as it isn't necessary but if you do glue yours REMEMBER to only glue into the bottom so you can still open the lid.

Tagi