Saitek X52 Magnet Mod
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This part makes the magnet relocation mod for the Saitek X52 Pro (and regular) easy - simply print two of them, remove…
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 107
- Wydruki
- 0
- Wyświetlenia
- 1665
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution
This part makes the magnet relocation mod for the Saitek X52 Pro (and regular) easy - simply print two of them, remove the base from your stick, remove the stock parts, install the stock magnets into the parts and reassemble.
Print Settings
Printer Brand:
Prusa
Printer:
Prusa Clone
Rafts:
No
Supports:
No
Resolution:
0.15mm
Infill:
15%
Filament: Generic PLA Post-Printing =============
Remove original magnet holders
You can remove the whole assembly simply by removing the two silver screws either side of the sensor. The magnet carrier slides out, then the gear part can be carefully unscrewed with a small screwdriver.
Install magnets into new part
Put both magnets from the original carrier into the new part - they should go "backwards" compared with how they came out of the original carrier. Mine were marked on the back with a line. If after assembly your axis is inverted, just flip the magnets over.
Install new parts and reassemble stick
The new parts attach as shown below. There should be a gap between the magnets and the sensors.
Category: Video Games