Chair Wheel Stopper
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Designed a chair wheel or castor stopper so that I could still use my chair to play racing simulators. The wheels are…
- Ocena
- 4,944 / 5
- Polubienia
- 121
- Pobrania
- 1567
- Wydruki
- 21
- Wyświetlenia
- 5937
- Oceny
- 18
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial
Designed a chair wheel or castor stopper so that I could still use my chair to play racing simulators. The wheels are 60mm diameter and 54mm width (60mm x 54mm). The chair I'm using is an Ergochair ripoff, so you shouldn't need to remix this if you have it or have a wheel size that's smaller than 60mm x 54mm. I used some rubber feet at the bottom. However, I have designed a simple feet that you should print in TPU if that's what you fancy. And of course, would definitely recommend printing the TPU feet in 100% infill. Overall, it works wonderfully well! Do post a make if you decide to print one :)
Print Settings
Printer:
Creality Ender 3
Infill:
10
Filament: Smith3D PLA+ Yellow
Notes:
From my experience so far, 10% cubic infill on Cura is sufficient. For the perimeters, I used 4.
Category: Office