Smart For Two washerfluid cap
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A friend of mine broke their Fluid Cap because it got brittle and there were no spare parts on the internet and not…
- Ocena
- 0 / 5
- Polubienia
- 17
- Pobrania
- 87
- Wydruki
- 0
- Wyświetlenia
- 352
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
A friend of mine broke their Fluid Cap because it got brittle and there were no spare parts on the internet and not even the dealer could provider her one. so i did what everyone would do, open up Fusion design a new Cap and print away.
The fit was tight and like the original cap. i dont know about the chemical resistance of PLA but in the end Washerfluid is just some fancy dishsoap, which should hold up just fine.
i even added the small tail, so the cap wont fall around the compartment. I tried several thicknesses to make it bendable with pla and i think 4 layers at 0,2mm should do the trick when you are not bendig it many times.
Category: Automotive