Brondell Swash 1400 Remote Hang Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I didn't like any of the options to wall mount the remote control for my Brondell Swash 1400 bidet seat's remote…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 189
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial
I didn't like any of the options to wall mount the remote control for my Brondell Swash 1400 bidet seat's remote control. I considered designing a shelf, but decided my best option would be just to hang it. To facilitate hanging it, I made a simple backplate for the remote mount. I attached with two M3x6 screws and associates M3 nuts.
- Print in provided orientation (flat side down). You shouldn't need supports.
- Designed parametrically in Fusion 360.
- Fusion 360 export included in downloads.
- I included both 3MF and STL mesh files. These should be equivalent, pick the one you like.
- Don't over-tighten. A small washer might be a good idea.
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK3
Rafts:
No
Supports:
No
Resolution:
0.3mm
Infill:
Default for Prusa Slicer
Filament: Hatchbox PETG White
Notes:
- This should print fine in pretty much any filament. I had white Hatchbox PETG loaded, so that is what I used. I provided a small amount of tolerance for the screw holes and nut inset. You might find these a bit tight, but I think it will be OK for most people. I printed at 0.3mm as I didn't feel the extra resolution was necessary. I don't think supports should be necessary. If the edges are too rough, you could certainly sand the piece. The texture doesn't bother me.
How I Designed This
Category: Bathroom