E3D Hemera Fan Mount with Inductive Sensor and BLTouch Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of the fan mount from Baphomet. It is meant for a 5015 radial blower fan.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 235
- Wydruki
- 0
- Wyświetlenia
- 2129
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
This is a remix of the fan mount from Baphomet. It is meant for a 5015 radial blower fan. I have included 2 different mounts, depending on the type of sensor you have. I used a 12mm (diameter) inductive probe but found it was inconsistent and have since switched to a BLTouch. They're both mounted to the side of the motor which should clear most printer frames.
The fan is positioned similarly to Anet A8 so I've found that some of those fan ducts will work, but they're often a little too short. If you use longer ones, they tend to work pretty well.