Ortur laser master 2 dragchain mounts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I didn't find any ortur laser master 2 drag chain mounts i liked so i decided to make my own. I think this should work…
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 82
- Wydruki
- 0
- Wyświetlenia
- 665
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
I didn't find any ortur laser master 2 drag chain mounts i liked so i decided to make my own.
I think this should work with any dragchain with a width thats roughly between 25 to 30 mm that you can mount using M3 screws and nuts. The one i used is 30mm wide.
-I used 15x15mm angled aluminum for the guide rails. Smaller should be fine too.
-Use M3 nuts and bolts to mount the dragchains, and guiderail clamps.
-Use M4 bolts and self locking M4 v-slot nuts to mount the Y axis dragchain mounts.
-Clamp X axis Dragchain guide mount - Left between the acrylic and the stepper motor.
-Use the acorn nuts on the oposite sides to mount X axis Dragchain guide mount - Right.
-The stepper motor mounts clamp in the middle of the stepper motors. (optional: Use zipties to secure them and keep them from bending long term)
Print one of each, except the dragchain guide clamp, you'll need two of those.
I know it's a confusing mess, but i hope everything is clear! Show me your builds if you decide to use my design!
Print Settings
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
2,5
Infill:
35
Filament: Polymaker PLA
Category: DIY