Centrifugal Water Pump Version 4 and 5
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Introducing Versions 4 & 5 of the water pump. Both are scaled up from the Version 3 and modified to make them about…
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 147
- Wydruki
- 0
- Wyświetlenia
- 1302
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
Introducing Versions 4 & 5 of the water pump.
Both are scaled up from the Version 3 and modified to make them about the right size.
Original Versions here: https://www.thingiverse.com/thing:4122545
Version 4 has a 19.5mm (3/4") outlet; but uses the Version 3 cover, impeller etc.
The pump drive shaft is based on a 4mm bolt.
Version 5 has a 25mm (1") outlet. It has it's own size of cover, impeller etc.
The pump drive shaft is based on a 6mm bolt.
Version 5 also uses a bigger motor, it is based on this one from a local electronics store. https://www.jaycar.com.au/standard-high-power-d-c-motors-10200-rpm/p/YM2776
Both pumps use brass nuts in the lid or cover as bearings. Just drill them out to slightly bigger than the bolt (i.e. 4.2 or 4.5mm for Ver 4 and 6.5mm for Ver 5)
Print Settings
Printer Brand:
Anet
Printer:
A8
Rafts:
No
Supports:
Yes
Resolution:
0.2mm
Infill:
30%
Filament: Any PLA Black
Notes:
Print with at least 3 top and bottom layers and 3 perimeters.
Category: Tools