LJ18A3-8-Z/BX 18mm Inductive Sensor Support Anet A8
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Slight re-mix of lukeskymuh 18mm Inductive Sensor Support. To save material; rounded off the section where the sensor…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 361
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
Slight re-mix of lukeskymuh 18mm Inductive Sensor Support.
To save material; rounded off the section where the sensor mounts and thinned down the plate where is is held by the part cooling fan screws to 3mm.
If I remember correctly it's slightly longer as well; to make mounting the sensor a bit easier.
16 March 2022
Added a version of the mount with rounded off corners for a better look. Also removed material from the part that is behind the fan, as it's not required, which saves a bit of filament as well.
Print Settings
Printer Brand:
Anet
Printer:
A8
Rafts:
No
Supports:
No
Resolution:
0.15mm
Infill:
100% (solid)
Filament: Any PLA Any
Notes:
Print upright as per the picture. No support needed.
Category: 3D Printer Accessories