Screw-on bubbler
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I like to brew my own non-gaseous drinks, specifically mead. This generates a LOT of CO2 gases, and you can't let it…
- Ocena
- 5 / 5
- Polubienia
- 2
- Pobrania
- 31
- Wydruki
- 1
- Wyświetlenia
- 365
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Share Alike
I like to brew my own non-gaseous drinks, specifically mead. This generates a LOT of CO2 gases, and you can't let it ferment to open-air either.
This is where you need a bubbler to act as a gaseous valve. In this particular instance, just screw it on your bottle top (I'm using cleaned soda bottles), fill the top with water up to below the inside gap, and voila!
Instructions
I printed mine at .10 mm on a replicator 2, with 4 perimeters and 30% infill. The part is solid, but don't over-tighten it.
I rotated it upside down to print, and added supports. Even if some support material is stuck in the "exhaust pipe", it doesn't obstruct the flow of gases, and works very well.
Category: Kitchen & Dining