360 Degree LED Indicator with WeMos D1 Mini ESP8266
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a 360-degree indicator with thirteen addressable RGB LEDs. It is WiFi enabled, powered by a WeMos D1 Mini.…
- Ocena
- 5 / 5
- Polubienia
- 21
- Pobrania
- 56
- Wydruki
- 1
- Wyświetlenia
- 665
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
This is a 360-degree indicator with thirteen addressable RGB LEDs. It is WiFi enabled, powered by a WeMos D1 Mini.
The parts all snap together with no adhesives or fasteners required. The WeMos snaps into the bottom tray, the top tray snaps on, and the lens ring snaps around the outside. The lens holds the LED strip in place and locks the top and bottom trays together. You can add plastic cement to make it permanent, but it isn't necessary.
Parts you will need:
*This site contains affiliate links for which I may be compensated
- WeMos D1 Mini ESP8266 Development Board
- WS2812B LED Strip (60 LEDs per meter)
I printed this with:
- eSUN 1.75mm Black ABS: http://amzn.to/2rDNnjC
- Transparent ABS
Print Settings
Printer:
MakerFarm Prusa i3v
Rafts:
No
Supports:
Yes
Resolution:
0.2mm
Infill:
40%
Notes:
Supports are required to print this successfully. Be sure to orient the trays with the flat sides down on the bed. Supports are required around the edges to support the lips that lock into the lens. The lens requires support inside to support the top ledge so it can snap around the trays.
How I Designed This
I designed this in Fusion 360. You can download the project here: http://a360.co/2s4TFt6
Category: Electronics