Blade mCP X Brushless Conversion Tail Motor Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a motor mount and tail fin for converting a Blade mCP X helicopter to brushless tail. It mounts to a 2mm solid…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 288
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Share Alike
This is a motor mount and tail fin for converting a Blade mCP X helicopter to brushless tail.
It mounts to a 2mm solid carbon fiber tail boom with a flat filed on the last 5mm of the bottom of the boom, just like the original and holds an HP03T tail motor.
There is also a 1-piece mount included if you don't wish to use a tail fin.
Instructions
The tail motor is a press-fit and should be secured with a drop of CA.
The screws I used are the same as the ones usually used to mount the 3N1 board to the helicopter frame.
Category: R/C Vehicles