95 Paracord Zipper Pulls
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Zipper nubbins for thin 95 paracord
- Ocena
- 5 / 5
- Polubienia
- 281
- Pobrania
- 958
- Wydruki
- 20
- Wyświetlenia
- 5016
- Oceny
- 14
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Fashion Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Following the example set by nemokeine the holes in these have been enlarged from 3mm to 4mm for an easier time getting the 95 paracord through armourcraft's models.
95 paracord is thinner than the more widely know 550 paracord.
Shown pictured with 6.25" pieces of 95 paracord tied into a loop for looping through one zipper hole and an 8.5" piece tied in a loop for looping through two zipper holes.
Printed here in ASA, but other materials should work too.
Print Settings
Rafts:
No
Supports:
No
Resolution:
0.16
Infill:
0.5
Notes:
printing one at a time caused layer sagging that appeared to be from insufficient cooling time between layers. Printing ten at a time did not have that same issue.
Remixed from
https://www.thingiverse.com/thing:2964645
https://www.thingiverse.com/thing:3123461
Category: Accessories