1 / 6
Numatic Henry 100mm to 32mm Vacuum Hose Connector (3D printed) — zdjęcie 1
1 / 6

Numatic Henry 100mm to 32mm Vacuum Hose Connector (3D printed)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Attach a Numatic Henry 32mm vacuum hose to your dust extractor's 100mm inlet.

Ocena
0 / 5
Polubienia
6
Pobrania
77
Wydruki
0
Wyświetlenia
695
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution — Noncommercial

Attach a Numatic Henry 32mm vacuum hose to your dust extractor's 100mm inlet.

Instructions

100mm piece develops a lot of tension - my bent a bit out of shape during printing. Could be improved by adding cut-outs, but it's working ok, so I stopped at "good enough" state.

Top part should be printed using 0.1mm or 0.2mm layers, for the threads to come out nicely. The 100mm plate must be sanded to fit really tight into the outer tube. I hammered mine in place (carefully), using a rubber mallet. Turned out it needed no gluing - friction was just high enough to hold both pieces firmly attached.

Category: DIY

Tagi