Dual Beater MK0.6.3 BETA- Flywheel Powered Dart Blaster

The Dual Beater is a 3d printed, flywheel powered, single stage (ish), semi-shotgun dart blaster. It uses dual magazines and pushers for individual cycle control using a three stage trigger. 

If you decide to build one, please contact me at @noreason#4172 on discord. My prototype that I've built upon in the past year functions reliably but yours may have unique quirks and tolerances that need ironing out.

The files up there are a mess in terms of organization but there is a fully updated STEP you can pull from in case there are any files missing.

WIRING NOTE: This blaster in my configuration does not use a MOSFET board but has fairly annoying wiring to figure out on one's own. It's essentially two rapidstrikes connected to one rev switch and one battery.

HARDWARE- (screws are a rough estimate from the last time I counted)

-142 flat head 4-40 screws, 104 for the main body and 38 for the accents and picatinny
-2 M2.5 (commonly found on store bought blasters) screws with a narrow head
-4x 130 motors
-2x N20 motors (1000rpm to 2000rpm is optimal)
-2 pairs of Daybreak Flywheels (currently only have a 41mm cage, i can make different sizes on request)
-a small rubber band or a length of elastic for the mag release
-2x inner barrels- can be 3/4 inch PVC or be printed (roughly 7.5 inches or 190mm)
-7x 4-40 nuts
-5x Omron 21amp microswitches
-Additionally, a lot of (preferably) 16 AWG wire

Happy building!*

*Please don't turn this into an injection molded knockoff without permission.

Firing Demo:
https://www.youtube.com/watch?v=GTHwKBlgr6c&ab_channel=noreason