Creality Ender 3 Pro- Dual Double Drawers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Edit: 10/13/20 Here's a public link to my project in Tinkercad! Feel free to remix it and make it your…
- Ocena
- 4 / 5
- Polubienia
- 67
- Pobrania
- 258
- Wydruki
- 7
- Wyświetlenia
- 1598
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Edit: 10/13/20
Here's a public link to my project in Tinkercad! Feel free to remix it and make it your own. https://www.tinkercad.com/things/4Xt4iDRlwDr-double-drawers-remix
Edit: 5/15/20
Added an empty upper and lower right side drawer. If you need it for the left side, just mirror it in your slicer.
Edit: 8/30/19
The two cases were a bit too tight to fit, so I removed one edge width from the cases and bottom drawers for a better fit under the Z rail.
I recently moved my Main Board and Raspberry Pi to back of my Ender 3 Pro with this remix of Teaching Tech's rear case.
That left me with tons of room in the front for storage.
I remixed these drawers to make room for two of them side-by-side. Remixing entailed narrowing the case to 125mm wide, narrowing the bottom drawer to match, and re-centering the bottom drawer handle. I then mirrored the right side in Tinkercad to make it easy for you to print the left side without any modification on your end.
Please orientate on the print bed according to the original instructions.
Category: 3D Printer Accessories