PINDA Calibration Strips
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Used to calibrate your PINDA height (rather than the wire-tie method in the manual).
- Ocena
- 5 / 5
- Polubienia
- 13
- Pobrania
- 66
- Wydruki
- 1
- Wyświetlenia
- 719
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- GNU General Public License v2.0
Rather than using a wire-tie, print this set of test strips to calibrate the height of your PINDA sensor on the i3MK3S+ or similar. If you're following the manual, start with the 1mm strip instead of the wire tie. Place your nozzle so that it is gently touching the bed, and then use the low side of the 1mm strip to calibrate the PINDA height.
If you notice that your live-Z is excessively low (below -1.0mm) you can use the low side of the 1.2mm-1.8mm calibration strips to raise the PINDA, which will raise your live Z (move it in the positive direction). If you notice that your live Z is excessively high (above -1.0mm) you can use the 0.8mm-0.2mm to lower the height of your PINDA, which will lower your live Z (move it in the negative direction).
This is all about fine tuning what you feel are appropriate values - the wire tie method is perfectly good - this just gives you some values of a known quantity to calibrate against.