1 / 1
Nerf N-Strike Recon stock reinforcement bar cutting jig — zdjęcie 1

Nerf N-Strike Recon stock reinforcement bar cutting jig

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Jig to cut any 3 mm rod stock to the right lengths to reinforce the thin pieces of the Recon's shoulder stock.

Ocena
0 / 5
Polubienia
2
Pobrania
9
Wydruki
0
Wyświetlenia
507
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Jig for cutting 3 mm round stock - I used carbon fiber rods, but anything sufficiently rigid should work - to the right lengths to reinforce a Nerf N-Strike Recon shoulder stock.

Cut four pieces at each length, total length of all the bars is 600 mm, so, round stock of just over 600 mm is required, to account for the width of the cutting tool. After each cut, use a thin screwdriver, or straightened out paper clip or similar, to push the rod out of the jig. Attach to the plastic bars in the shoulder stock using epoxy, or a different suitable adhesive.

All tools and parts used shown in uploaded picture, also showing dry fit of the cut rods in the stock. Afterwards, used two-part epoxy to glue the reinforcement rods into the grooves of the shoulder stock's connecting bars.

Tagi