Tarmo4 TPU Bumper
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a bumper that is designed to be printed in TPU (I use Inland TPU) and attaches to the bumper bracket from…
- Ocena
- 5 / 5
- Polubienia
- 7
- Pobrania
- 52
- Wydruki
- 1
- Wyświetlenia
- 695
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Share Alike
This is a bumper that is designed to be printed in TPU (I use Inland TPU) and attaches to the bumper bracket from https://www.thingiverse.com/thing:4306573 with m4x20mm screws, which I had left over from assembling the Tarmo4.
I printed with 6 walls and 20% gyroid infill for it to have a reasonable amount of stiffness, since I wanted the bumper to absorb some impact, but didn't want it to be too squishy. This was accidentally tested by taking a hill too fast, which cause the car to arc nicely in the air, land vertically on the bumper, and proceed to flip over without any damage. :)
Category: R/C Vehicles