Belt 2.2

This is a wearable, articulated, print in place, super fashionable 3d printed belt.
Enjoy!

Print instructions

Blank buckle
If you want to support me get the belt without a logo here:
https://www.printschnitzel.at/belt

You can always remove the Logo with a tool like meshmixer
If you don't know how to do that and can't effort the files drop me an email: [email protected]
There is even a .step file ;)

 

Please take note:

• Use 4 perimeters
• Before printing please make sure to print the file Testprint-2-2.stl first
• If the hinges are welt together it helps to set a horizontal expansion (Cura) or XY- size compensation (Slic3r) of up to -0.1. Don't go much smaller because it weakens the hinges.

Find your size:
The number at the end of the file name is the length of the belt in milimeters measured from the hooks to the middle (the 3rd) element with the corresponding grooves. In short: The number should be close to your hips measurement. Please measure your hips where you wear your belt. Do not convert your usual belt length because it often turns out to be to short.