Wera Kraftform Screwdriver, Hex & Torx Driver etc. Set Rack Pegboard Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 1"/25mm pegboard adaptor for Wera Kraftform Screwdriver, Hex & Torx Driver etc. set racks.
- Ocena
- 4,333 / 5
- Polubienia
- 28
- Pobrania
- 155
- Wydruki
- 4
- Wyświetlenia
- 2420
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Two adaptor brackets which, when combined, allow for the installation of Wera Kraftform Screwdriver, Hex & Torx Driver etc. racks with 1"/25mm pegboard.
The adaptors are based on an stl file I found online designed for IKEA Skadis rack mount system (thing:5264447). The design wasn't as good as it could be, plus it was not compatible with pegboard, so I significantly reworked it so that it fits my pegboard and also better fits the Wera racks, giving them more rigidity.
The pegboard hooks are tailored for my Sealey steel pegboard. They will probably fit other makes, but may need a little fine tuning of the gap between the back of the adaptor and the forward face of the hooks to nip up nice and tight (or loosen off if too tight).
These need to be printed on their side, with various supports for the hooks, pegs and other overhangs (as per the gcode file I've also uploaded). I have the two adaptors so there's around 0.5-1mm space between them once installed, which provides a little tolerance for Wera rack manufacturing variations: you may not see any gap, depending on your rack and also the pegboard.