1 / 3
Turbine Extruder Motor Visualizer Press Fit Edition
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of the Turbine Visualizer from PaoloG that press fits onto a normal Nema 17 instead of using a magnet.
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 124
- Wydruki
- 0
- Wyświetlenia
- 733
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (4)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (20)Powiązane
Simple Remix of his design, the only part I made is the conecting piece for the Stepper.
It should just press on with a little bit of force but ive found it helps to do it right after finishing a print so the shaft is still a little warm or to heat up the connector a little before fitting it. its probably a good idea to test fit it before glueing it to the Turbine itself.