Skew print test 280mm x 280mm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Skew print test This is a version I made from https://www.thingiverse.com/thing:2805032 design. My use is to verify /…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 186
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Skew print test
This is a version I made from https://www.thingiverse.com/thing:2805032 design. My use is to verify / adjust CoreXY belts to correct any Askew alignment without modifying software.
I needed a larger version for my 300mm x 300mm bed. This is 280mm x 280mm
Also I made things larger and easier to see if anything is askew.
Placing metal straight edge in 2 corners will press up against large areas, if 2 corners and center all touch with no space at any point all is good. Then check other direction.
The idea is by looking you could measure how off one side is without using a measuring device. Ideally not even a thin film or measuring shim will fit between the straight edge and any of the 3 points. Not perfect but once you start tightening the belts you can notice the changes and hopefully help to get finial alignment.
The means I adjust my Z9M3 CoreXY printer can be found here. https://www.thingiverse.com/thing:3038877
This file so far for me has been to verify, I properly adjusted the belts, so I have not used this yet to Fix Askew alignment, just used it to verify I was good
Enjoy!
`mike
Category: 3D Printer Parts