XT60 Plug Housings
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A set of covers for a straight-through XT60 connection (mainly so I can avoid shrink tubing). Has 2 separate 4mm…
- Ocena
- 4,947 / 5
- Polubienia
- 281
- Pobrania
- 1708
- Wydruki
- 23
- Wyświetlenia
- 5020
- Oceny
- 19
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
A set of covers for a straight-through XT60 connection (mainly so I can avoid shrink tubing).
Has 2 separate 4mm diameter wire holes. The fit is a bit loose but suits my requirements.
I printed on a raft - without one, you may need to cut some of the inner edge to fit the connector. Note that not all connector brands may be the same.
No supports needed.
SAFETY: Please please keep in mind that you should solder your connectors really well. With these covers you won't be able to see if the wire might have come loose inside - so it is probably still safer to individually heat shrink the connections, especially if you are sending a lot of unfused current down them.
How I Designed This
Fusion360 - Drawings, Extrusions, Offset Planes, 1 Loft Extrude + 2 Loft Cuts, Edge Radius
Drawings, Extrusions, Offset Planes, 1 Loft Extrude + 2 Loft Cuts, Edge Radius
Category: R/C Vehicles