portafilter handle sleeve
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This thing is something very specific again: a replacement for the portafilter rubber sleeve of the gastroback…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 188
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This thing is something very specific again: a replacement for the portafilter rubber sleeve of the gastroback advanced pro g design espresso maker (also sold with dozens of other brand names).
There's not much to say except that the original sleeve doesn't hold up very long and is of a very soft type of rubber. Since I don't have filament that soft, I can't stretch an exact replica over that ridiculously sized filter handle. Therefore I had to make the replacement with an opening which you can close by using a nut (M3 square) & screw (M3x6 countersunk). Not very graceful but looks better than that ripped old thing.
Print Settings
Printer Brand:
Wanhao
Printer:
Duplicator9
Rafts:
No
Supports:
Yes
Resolution:
0,25mm
Infill:
100%
Filament: Recreus TPU 82A orange
Notes:
Use soft TPU and some support.
Category: Kitchen & Dining