Diff-Probe DIN-rail mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a rather specific one but maybe someone could find it useful. It's a DIN rail mount for the ADP305 diff-probe…
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 216
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a rather specific one but maybe someone could find it useful. It's a DIN rail mount for the ADP305 diff-probe for LeCroy oscilloscopes. I guess I'll adapt it to fit other diff-probes or similar shaped gadgets as well someday; if you have any suggestions I'd like to hear them.
I split it up in 3 parts to avoid excessive use of support and to make a cleaner print. Unfortunately there's 2 screws (M2,5 x 20) and a tiny amount of glue involved which doesn't qualify it for a graceful design.
Print Settings
Printer:
Intamsys FunmatHT
Rafts:
No
Supports:
Yes
Resolution:
0,1mm
Infill:
100%
Filament:
Polymaker PC
transparent/black
Notes:
To have a better view at the mechanism I decided to print it in translucent polycarbonate; it's also very flexible which makes it easier to install the snap-in thingy. But any PETG or maybe even PLA should be fine too.
The main part and the snap-in-thingy need a bit support for angles >88%.Category: Electronics