1 / 9
120 / 140 mm Build Chamber Fan mount for CTC / Flashforge / Makerbot Replicator — zdjęcie 1
1 / 9

120 / 140 mm Build Chamber Fan mount for CTC / Flashforge / Makerbot Replicator

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a quick design I made to add two 120 or140 mm fans (one on each side) to my CTC's build chamber.

Ocena
0 / 5
Polubienia
2
Pobrania
31
Wydruki
0
Wyświetlenia
711
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a quick design I made to add two 120 or140 mm fans (one on each side) to my CTC's build chamber.
Goal was to make a fan mount, which can be easily removed when you have to access the print bed from the side (i.e. to apply blue tape, capton tape).
The bottom bracket has slots so you can adjust it to different fittments (CTC doesn't have the best quality crontol).
I run all my additional fans of a PC fan-controller I build in my printer, I power it from an external 4-pin Molex PSU.

I designed to versions. One "full" version with complete brackets, and a "small" version with split bracktes (for easyier printing in ABS for less warping).

Print instructions

Category: 3D Printer Accessories Print Settings

Printer: CTC 3D

Rafts: Doesn't Matter

Supports: Yes

Resolution: 0.2 mm

Infill: 25 %, 4 Shells

Notes:

The support is importent for the "grooves" which hold the brackets on the printers frame.

Tagi