Backpack Lower Exterior Gear Hooks
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This design is meant to attach a tool roll (or yoga mat, bed roll, etc.) to the bottom of a backpack.
- Ocena
- 0 / 5
- Polubienia
- 27
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 973
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
This design is meant to attach a tool roll (or yoga mat, bed roll, etc.) to the bottom of a backpack. My tool roll is too large to fit in my bag with the rest of my drone gear, so I needed to mount it to the bottom of my bag.
I printed two of each of the hook and back plate in order to make this work.The plates are attached with five M4x16 screws, with two counter-tightened nuts on the backplate. It is very important to have something rigid to affix between the plates when bolting them together. In my build, I used some 1/2" aluminum stock from Home Depot that I cut to 12" in length. After filing down the cut ends of the bar, I slid them between a gap in the back plates before re-seating the screws to clamp the back plate firmly down over the bar. If no aluminum or steel stock is available, wood may be a good alternative material to keep the hooks aligned with one another.
Category: Tool Holders & Boxes