Vase Mode Dice Tube
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Vase mode dice tube for 24 and 26mm dice, holds 10.
- Ocena
- 0 / 5
- Polubienia
- 20
- Pobrania
- 58
- Wydruki
- 0
- Wyświetlenia
- 386
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Board Games
- Licencja
- Creative Commons — Attribution — Share Alike
Dice Tube printed in vase mode. Can carry up to 10 24mm or 26mm dice. with 0.4 mm extrusion width, printing this only requires about 3.5m of filament and for 0.6 mm, just under 5 is required.
PLA works fine for me but I would recommend a tougher filament like PETG if you expect to toss it around a lot. When printed in a clear filament, you get a trippy lenticular lens effect when the tube is held sideways.
Printing
for the lid to fit you will need to set your extrusion width. In PrusaSlicer:
- Toggle advanced settings to on:
- Go to the “Advanced” section in Print Settings
- Change your extrusion width to either 0.4 or 0.6
choose the respective model for whichever extrusion width you choose. Remember to print with spiral/vase mode.