1 / 6
Ikea Stuva cabinet reel holder and filament guide — zdjęcie 1
1 / 6

Ikea Stuva cabinet reel holder and filament guide

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I wanted a mount for the filament reel that went inside the nice new Ikea Stuva Cabinet but I also wanted it to leave…

Ocena
0 / 5
Polubienia
5
Pobrania
28
Wydruki
0
Wyświetlenia
268
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution

I wanted a mount for the filament reel that went inside the nice new Ikea Stuva Cabinet but I also wanted it to leave the cabinet as undamaged as possible, so decided to use the pre-existing shelf mount holes.

The mount fastens on with 4 screws and there are also two additional parts to guide the filament off the reel and into the printer without getting snagged. One for the side, which also screws into a preexisting hole, and a new piece to the top frame on the printer, and a piece of 6mm outer / 4mm inner diameter ptfe pipe to guide the filament safely between the two.

I used PETG for strength but PLA would probably be fine too.

Print Settings

Printer Brand:

Wanhao

Printer:

Wanhao Duplicator i3 V2

Rafts:

No

Supports:

Yes

Resolution:

0.2

Infill:

20%

Filament: Reel PETG

Notes:

Print the reel mount flat on the bed with the column vertical, rotate it to 45 degrees to make it fit onto the build plate

Category: 3D Printer Accessories

Tagi