Raspberry Pi / Pi Zero W GoPro-style Camera Mount

Included here are the camera mount and swivel components, with a GoProStyle mating joint. Pictured in the first photo, are also a Raspberry Pi Zero W ultraSlim mount, found here: https://www.thingiverse.com/thing:2504847 and GoPro Mount arms & base found here: https://www.thingiverse.com/thing:2194278

This model is a slight remix of a model found here: https://cad.onshape.com/documents/38b99c4a6ea986a38ce072ee/w/75caf2f3a76fdf77faa14ea2/e/c6ac5f945c5a0bb05d541a37

The requirement of screws into the camera case was eliminated, in favor of swivel pins, to be installed after printing. You'll need to print two pins. There are two separate pins files but they're identical. I used an M3 screw (20mm) and nut to fasten the base to the swivel, although if you prefer to use all printed parts, you should be able to use this set of fasteners: https://www.thingiverse.com/thing:192259

Print Settings

Printer Brand:

Prusa

Printer:

Rafts:

No

Supports:

Resolution:

0.2mm

Infill:

Post-Printing

This design requires a little assembly. First, be sure you've secured the camera cable to the Pi camera board, then insert the camera board into the front of the camera case, pressing the back of the case into place until it clicks into place. Slide an M3 nut between the two legs of the GoPro-Mount-style base. It will be held in place by the mount legs. Insert the M3 screw through the swivel bracket, and base, securing it through the M3 nut, screwing in hand tight, then backing off one rotation. Insert the swivel pins into each of left and right holes in the swivel bracket. place the camera case between the pins, such that the pins pop into place in the holes on either side of the camera mount. This might require some outward pressure separating the arms of the swivel bracket to accommodate the camera case, while moving it into position.

Category: Camera