Suzuki Andes Clone - unfinished

WARNING: Unfinished! Has never been printed in one piece!
 

The idea was to make a clone of a Suzuki Andes which is a 'pipe melodika'.

I found the measurements of pipe sizes on some pages about pan flutes.
I did a few testprints with differnet single pipes to experiment with length and diameter and sound hole shape. This is the result.

The (non-existant) keyboard should close each flute at the side opening and open it, when the key is pressed to let the air out.

There is probably a lot of fine tuning required to make this work.
The code contains some magic numbers which seemed good at some point.

Made with OpenSCAD.