Honda lawnmower throttle handle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A replacement throttle handle for Honda HRT lawnmowers.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 106
- Wydruki
- 0
- Wyświetlenia
- 1111
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Share Alike
This is a replacement handle for Honda HRT lawnmowers. The original one broke on my mower, but the housing was not broken, so it only needed the lever part. Includes a cover for the side of the throttle lever if needed.
The old lever can be removed and replaced with common hand tools. It was a pretty simple affair if you pay attention to where the cables go.
Print in PETG since this will be outside quite a bit. Mine has held up for at two summers going into a third summer.
Print Settings
Printer: Ender 3 Pro w/ direct drive
Material: PETG
Rafts: No
Supports: No
Resolution: 0.15-0.2mm
Infill: 30% or higher
Shells: 2+