Dojo Case for Raspberry Pi 4
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ronin Dojo Case remix for Raspberry Pi 4B with or without POE+ Hat.
- Ocena
- 5 / 5
- Polubienia
- 56
- Pobrania
- 226
- Wydruki
- 2
- Wyświetlenia
- 1368
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
This is my first Fusion 360 project to remix CrazyK's Rockpro64 RoninDojo case to fit Raspberry Pi 4. As I uses POE+ Hat with mine, it is made with fitting a POE+ Hat in mind. As I barely begun using Fusion 360 I lack the skill to make this case a snap fit, so you will require the following to put the case together.
- 4x M3x8mm screws.
I've modelled in studs for the RPI to sit on, as long as you don't flip the case it should sit just fine with gravity.
---
Printing material:
Speaking from personal experience, if you are using POE+ hat with your Pi I highly recommend printing the foundation and wall with PETG. The roof can be a cheap filament like PLA as it wouldn't withstand as much heat. I've had PLA cases warp as a RPI with POE hat runs pretty hot.
Support:
Only roof.stl and wall_poe.stl requires touching buildplate only support. The rest can be printed without.
---
wall_poe.stl is made with the measurements of the official POE+ hat measurement, other POE+hat may not fit. Other than that the case is quite a tight fit, you have to push the ports hole in the RPI, once it's fitted together it won't get loose. The roof just sits on top, providing easy access if needed.
---
I've included STEP file for any interested parties, enjoy!