Antique Door Stop Bumper Tip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I live in a house that's well over a hundred years old, and one of the bumpers from an old doorstop finally just…
- Ocena
- 5 / 5
- Polubienia
- 6
- Pobrania
- 43
- Wydruki
- 1
- Wyświetlenia
- 190
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
I live in a house that's well over a hundred years old, and one of the bumpers from an old doorstop finally just disintegrated from age. I could have gone to a big box store and bought a cheap replacement doorstop, but what's the challenge in that?
(Cue my wife rolling her eyes.)
Print Settings
Printer Brand:
Printrbot
Printer:
Printrbot Plus
Rafts:
No
Supports:
No
Resolution:
.2mm
Infill:
100%
Notes:
I used white Ninjaflex TPE filament at 245C, printing at 10 mm/sec. It has just the right amount of "give". Not too soft and not too hard.
How I Designed This
123D Design
I modeled this in 123D Design using only primitive shapes. A lip was included on the end so it would snap in place like the original one did. No adhesives required.
I'm including the 123D file in case someone would like to modify the bumper.Category: Replacement Parts