Dual Brush Hook for Kitchen Faucet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Designed to hang scrub brush from kitchen faucet. Has two hooks for brush and other. Quick print, no support needed.
- Ocena
- 5 / 5
- Polubienia
- 13
- Pobrania
- 117
- Wydruki
- 2
- Wyświetlenia
- 647
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
My wife hated when I would place the wet scrub brush over the side of the sink when I was done with the dishes and she hated it more when I would place the scrub brush in the sink … so this was my solution.
Designed in FreeCAD with two hooks at 90-degrees which allows for more than one utensil or brush. The hooks are a bit fat (or is that Thicc?) to make them more durable.
It's a simple model and a quick print. No supports needed. I printed using PLA because I had gray PLA … it would be better to print out of PETG. When I installed mine, it creaked a bit as it spread apart, but snapped into place. So far, after many months, we've had NO issues. PETG might give a bit better than PLA.
Your faucet diameter might vary, scale up or down to suit. My faucet has a small lip this rests against, yours might simply taper.