Upper clip for a Seckit SK-Tank 5015 fan duct upgrade
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Christian Söderlund's superb dual 5015 fan ducts draw cool air from left and right but the design was specific to the…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 120
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Christian Söderlund's superb dual 5015 fan ducts draw cool air from left and right but the design was specific to the Seckit SK-Go. To fit the SK-Tank with carbon fibre carriage without design change would require drilling 2 holes through the 3mm carbon fibre close to an edge. No, thought not. This (very) simple clip secures the upper part of the fan holders instead. Lower fixings are M3 and are common to both printers. The fan ducts Github link is on the Seckit SK Facebook group. I don't want to post it here as Seckiteers are the only interested folks.
Print Settings
Printer:
Seckit SK-Tank
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
100%
Filament:
eSun PETG
Any
Category: 3D Printer Parts