DROK LM2596 power supply box
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A snap-together, no screw or glue, print-and-use box with integrated buttons for the DROK LM2596 DC-DC power supply.…
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 37
- Wydruki
- 0
- Wyświetlenia
- 699
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
A snap-together, no screw or glue, print-and-use box with integrated buttons for the DROK LM2596 DC-DC power supply. This is for the version with display and 4 buttons, with or without heat sink.
This box is higher than necessary just to house the board because I wanted a 5mm barrel connector above the board and both input and output at one end. You may want another arrangement. If so, reduce the height of the box and all 8 ‘pillars’ on the lid equally.
The board is sandwiched between 4 of these pillars and spigoted location pads on the box. The lid snaps (4) into side vents on the box. The display sits in a ‘well’ by design to mask glare in a late-night audio setup. A vent on the box bottom is blocked if sitting on a flat surface.
Printed in PLA for a <3V voltage drop (which doesn’t get warm). If I wanted the board to do more work, I would print in PETG or even nylon, adding feet and vents. As ever – caution when mixing electrics, heat and plastic!
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
15%
Filament: flmnt.tw PLA white
Notes:
Supports recommended for the box side vents to provide a decent look and good location for the snaps. Print box right way up but lid inverted.
Category: Electronics