Rob's Bathtub Wine Holder (parametric)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is clearly a re-work of downmoney (Michael Lotkowski)'s Bathtub Wine Holder, this version in OpenSCAD with…
- Ocena
- 0 / 5
- Polubienia
- 18
- Pobrania
- 57
- Wydruki
- 0
- Wyświetlenia
- 564
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution
This is clearly a re-work of downmoney (Michael Lotkowski)'s Bathtub Wine Holder, this version in OpenSCAD with MakerBot Customizer controls.
The original version didn't fit my tub, which I attributed to the tub wall thickness and inside angle, however in testing my client preferred an installation and orientation I had not intended. I therefore added more variables to meet the new requirements. For my local installation I used: tub_Wall_Thick=60; tub_Wall_Angle_1=10; tub_Wall_Angle_2=0; stem_Slot=14; glass_Angle=10; glass_Offset=-30; flip=true;
The default version supplied here is just flat; our own instance angles it up a bit to get the foot out of the water.
I also added parameters 'test' and 'testDepth' to generate just a slice for checking the fit before printing the final model.
Uses Anaximandro de Godinho's CubeX code.
You may find it prints better on its side depending on your options and printer.
Updated 06 April 2018 to make the stem hole where the glass sits a separate parameter from the stem slot.
Category: Bathroom