32 x 18650 Lithium Ion Cellholder for storage (Quick Print)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple 18650 Batterycell holder I designed that focuses on low print time and low material usage.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 112
- Wydruki
- 0
- Wyświetlenia
- 536
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
EDIT: UPDATED VERSION HERE https://www.printables.com/model/214530-32-x-18650-lithium-ion-cellholder-for-storage-quic
I wanted to store a large amount of 18650 batteries I tested with my Megacellcharger. Since I own two of them I needed a holder that stores 32 cells in one go.
There are some designs for cell organizers out there but none print fast nor use as little material as possible.
This is where my design comes in! The hole diameter is 18.6mm in the drawing but depends on your printers accuracy when printed. Also some batteries like the SE US18650 VC7 who are 0.2mm wider than the LGDBMG18650 ones, need the model to be scaled in the XY-dimensions. I wanted a thight fit on my cells so a little experimentation is needed. For me the XY-Scaling lays between 100%-101%. And it takes about 1h30min to print.
For print settings I use:
Slicer: Prusaslicer/Superslicer !!!CURA DOES sometimes NOT SLICE THIS PRINT CORRECTLY AS OF NOW!!!
Layerheight:0.2mm
Speed: Shouldn't matter
Mode: Vase Mode!
Top/Bottom Layer: 0/3
I designed this print in such a way that vase mode can be used to speed up the print time even further! So I recommend everyone using it, it works great for me.
If you liked the design I would really appreciate you posting a comment and a make!
If you feel generous you could even donate me a coffee since this took pretty long to make! Thank you!