Current Meter for DC C02 LASER Tube
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My RECI-brand C02 LASER tube is designed to run at 28 mA. The manufacturer says to keep it at 26 mA if you would like…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 135
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Share Alike
My RECI-brand C02 LASER tube is designed to run at 28 mA. The manufacturer says to keep it at 26 mA if you would like the 10,000 hour life. With my cutter, I could not use 100% power and stay within these limits. In fact, my power has to be set to 77% to be at 26 mA.
Make the enclosure from glued 5mm wood or Acrylic, and install a 30mA meter meter in it. I used this one:
Wire the meter in series with the wire that connects to the LASER tube near the emitter. If the needle moves to the left, then reverse the polarity.
You can then adjust your power supply to put out the recommended max current when your software is asking for 100%. For my Z4 tube, that is 28 mA.
Category: Other