Pooh - Sun Catcher
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I wanted to see if it was possible to print a sun catcher without fancy multilateral mechanisms.
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 70
- Wydruki
- 0
- Wyświetlenia
- 466
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Art & Designs
- Licencja
- Creative Commons — Attribution
I wanted to see if it was possible to print a sun catcher without fancy multilateral mechanisms. So here is one of my attempts. This time its Pooh himself of Winnie the Pooh fame.
The frame acts like the leading in a stained glass window. It needs to be printed in transparent filament with a change to black at the layer where the lead lines would be.
Once completed, the coloured pieces are then glued into the relevant "gaps" in the frame. I used PVA glue and allowed it to set over a number of days.
I used PLA for the filament, sometimes I had to use PET as I couldn't find a translucent/transparent PLA of the right colour. This mostly worked, but sometimes I had to sand the PET pieces down a little to make it fit.
Print instructions
Category: 2D Art