Cat / Dog Biscuit + Water Dispensers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
NEWEST Update V6.0a Added a full new thread that supports 65mm mason jar perfectly
- Ocena
- 0 / 5
- Polubienia
- 56
- Pobrania
- 491
- Wydruki
- 1
- Wyświetlenia
- 3350
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Animals
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
PET BISCUIT DISPENSER and WATER DISPENSER BOWL
(still in development 5 years later)
- NEWEST Updated to V6.0a Added a full new thread that supports mason jar perfectly
- Vers 5.0 Altered the angle of the dispensing chute and opening, plus rounded all the internal angles to reduce blockages.Reduced the amount of polygons to print a little quicker. Reduced the amount of supports needed. If your printer will print 58deg or higher you may not need supports at all
- Updated to Vers.3.5 Altered the bowl radius too allow more biscuits in the bowl at any one time
- Updated Food dispenser Vers.2.6 Much larger bowl so that our furry friends can get their heads nearer to the bowl + It is better for dogs too, being a bit larger. I have made a reduction ring for this feeder to take 65mm jars that are more common in europe to fit the bowls 60mm fitting.
-------------------------------------------------------------------------------------------------------------
WATER DISPENSER BOWL
The white bowl in the photos is for water using a 300ml/500ml drinks bottle.
I remixed the water dispenser from https://www.thingiverse.com/thing:38224. I smoothed out the original pointy end so my cat could get to the bottom of the bowl a bit easier as as she doesn't like using deep bowls (fussy cat)
- Also included the cat-drinkpond-tower.stl, and Water bowl-Fish_MkV.stl these are for adding bottles of water to your existing cats / dogs bowl. Just screw it to a 300ml/500ml bottle and turn it upside down, no more things are needed to let your furry friend have enough water for a couple of days
- P.S. My 3 cats love it
------------------------------------------------------------------------
Print Settings
Printer Brand:
Creality
Printer:
CR-10 V2
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
15% bowl, 65% ring
Filament: Anycubic PLA Purple
Notes:
Pet biscuit dispenser is for 65mm mason jar
Water bowl v3 / v5 is for 300ml/500ml bottle
Water bowl TOWER is for 300ml/500ml bottle in your own pet bowl
Category: Animals