Light Up Decorative F1 Logo - Formula 1
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of BTR3D's original stand, but alterations made to base to allow for LEDs and wiring. Use original file for logo.
- Ocena
- 0 / 5
- Polubienia
- 41
- Pobrania
- 111
- Wydruki
- 0
- Wyświetlenia
- 2005
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Sculptures
- Licencja
- Creative Commons — Public Domain
I took this original model and changed it a bit to allow for LEDs and wiring. I had to create holes for the LEDs, for the switch, and then I hollowed out the bottom to provide space to hide the wires. The bottom has a little tongue that easily slides in and out in case you need to access the wiring. The circuit diagram is attached, and I've included Amazon links to all electronic parts. Current set up is 7 1.5 volt batteries taped to each other (inefficient and risky, I know, but I just wanted to get it working and will be making safety improvements later).
I used supports on the build plate only.
I printed it at 150% because I liked how it looked, but it will work just fine printing regularly also. Arguably the light will shine through even better.
For the logo itself, I used the original file provided and set it to 0% infill, then after it was done printing, carved a little hole in the bottom to allow the LED to go inside the logo while still being able to sit correctly on the base.
Hatchbox's Transparent Red PLA works nicely.