1 / 6
ABI 24V 500W Power Supply Cover Plate - REMIX — zdjęcie 1
1 / 6

ABI 24V 500W Power Supply Cover Plate - REMIX

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This REMIX of mrpaulwoods design uses a different switch assembly. v1 has a horizontal switch, v2 has a vertical…

Ocena
0 / 5
Polubienia
4
Pobrania
48
Wydruki
0
Wyświetlenia
441
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This REMIX of mrpaulwoods design uses a different switch assembly. v1 has a horizontal switch, v2 has a vertical switch. Both v1 and v2 have mounting wings.

Purchase Items:

ABI PSU - https://www.amazon.com/gp/product/B01IU8QBCO

Switch Assy. - https://www.amazon.com/gp/product/B00ME5YAPK

XT60 Connectors - https://www.amazon.com/gp/product/B07CWF8CRX

12 AWG Wire - https://www.amazon.com/gp/product/B00TG1TSUC

Notes:

  • ABI PSU - Fan can get noisy, so plan on replacing it at some point. All three 24v taps are on the same rail. total is 500W
  • 12 AWG Wire - Can use automotive 12 AWG wire, but the silicon wire is more flexible.
  • XT60 connectors - Makes it nice and easy for adding components.

STL Notes:

I printed in PLA. The initial prototype tests made to test XT60 clips worked well with no issues and the XT60 slipped into the opening nicely. After printing the entire case, one clip from each XT60 snapped off, and there is a tight interference fit between the case and the XT60 connectors. If you have issues, just add a spot of glue to hold the XT60 connectors to the case. PETG offers more flex, so it might be the better material to use.

Assembly Notes:

  • Remove aluminum end-plate by connector rail, save the 4 screws for securing the case to the PSU
  • Solder lengths of 12AWG wire to each XT60 terminal and snap on end cap. I put the red wire on the square end (left side). Fasten fork spade connectors on the other end of each wire. Make 3 sets.
  • Slide XT60 connector into the cover plate from the side. Be careful not to push too hard or clip can snap off. Might try warming up the clip area just before assembly.
  • Wire up the switch assembly. Use 14-18AWG wire from a PC extension cord if you need wire. Fasten fork spade connectors to the end of each HOT, NEUTRAL, and GROUND. Assemble to cover plate using two #6-32 screws or similar metric size.
  • Screw down each fork space connector to the corresponding terminal on the PSU.
  • Carefully route wires into PSU/Cover Plate and screw cover plate to PSU using the four screws that held on the aluminum plate.

Print Settings

Printer:

Anet A8

Rafts:

No

Supports:

No

Resolution:

0.2 to 0.3mm

Infill:

35% Cubic

Filament:

3D Solutech PLA

Category: 3D Printing

Tagi