Piper 2 500mm+ Belt Clamps - Tensioner side and slave side
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
When building my Piper 2, 500mm+ gantry, I had issues with the 10mm wide belt being pulled out of the slave side when…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 109
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
When building my Piper 2, 500mm+ gantry, I had issues with the 10mm wide belt being pulled out of the slave side when applying tension the opposite side.
These little gadgets will clamp on the belt, keeping it from sliding around and out.
My belts, when doubled up, measured 2.15mm
Print Settings
Printer:
Anet A8
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
35%
Filament:
3D Solutech PLA, but really shouldn't matter
Black
Notes:
Print 2 of each .STL.
Other parts:4 - M3 nuts
2 - M3 x 8mm SHCS
2 - M3 x 16mm SHCS
Category: 3D Printer Parts